INST No.INE-459-0P2CE Ver. 1.11
- 16 -
6.3 Memory full
The data storage number is up to No. 100. When a measured data is stored in the data storage No.
100, the memory becomes full and new measured data can not be stored after that.
6.4 Erasing all stored data
When all data being stored are not necessary or the memory becomes fill (Ref: [6.3 Memory full],
take the following procedure to erase all stored data.
• Press
MEM
key in the hold mode on the standard or continuous measurement mode to move to
the data storage mode. The " " mark under the main marker "
MEM
" will light. (The " "
mark will blink on the memory full condition.
• By pressing
SEL
key for about 2 seconds in the hold mode, a parameter will be displayed in the
main display and its item will be displayed in the sub display.
• Press
SEL
key to display "
AdEL
" in the sub display.
• At the first time, "
no
" (deletion disable) will be
displayed in the main display.
• By pressing
△
or
▽
key, either "
no
" (deletion
disable) or "
yES
" (deletion enable) will blink in the
main display.
• For the deletion of all data stored, select "
yES
"
(deletion enable) and then press
ENT
key. "
dEL
"
will be displayed instantly and then "
no
" will light in
the main display.
If no data have been stored, "
non
" will be displayed
instantly and then "
no
" will light in the main display.
• If you do not want to delete all data stored, select
"
no
" (deletion disable) and then press
ENT
key.
The blinking of "
no
" will stop and "
no
" will light.
• To quit this mode, press
SEL
key for about 2 seconds.
6. Temperature data storage.
*
Make sure to press any keys until you hear an audible beep.
Tb CONT MEM PEAK
MEAS
HOLD
AL
AH
C
F
MAX
AVE
ε
r
MIN
TC
NO
Main display
Sub display
Tb CONT MEM PEAK
MEAS
HOLD
AL
AH
C
F
MAX
AVE
ε
r
MIN
TC
NO
Main display
Sub display
• On the memory full condition, the " " mark under the main marker "
MEM
"
will blink.
• In the measurement mode or the hold mode, by pressing
ENT
key, the measured
data (thermometer temperature and emissivity rate) will be stored.
• The sub display will display "
Str
" instantly when the measured data is stored and,
when the measured data is stored on the data storage No. 100, the memory
becomes full.
• The sub display will display No.
100
and the main marker "
HOLD
" will light
continuously.
Further the " " mark under the main marker "
MEM
" will blink continuously.
After that, any measured data can not be stored.
On this condition, if
ENT
key is pressed for storing a new measured data, the sub
display will display "
FULL
" instantly and then display No.
100
.
R e m a r k s
• For storing a new measured data on the above condition,
1) Store the new measured data in the data storage number, that have not stored
any measured data, by referring to [6.2.1 Data storage number setting], or
2) Store the new measured data in the data storage number, that can be
overwritten, by referring to [6.2.1 Data storage number setting], or
3) Store the new measured data by erasing the measured data stored, by referring
to [6.4 Erasing all stored data].
Reference
• The initial is "
no
" (deletion disable).
R e m a r k s
