INST No.INE-459-0P2CE Ver. 1.11
- 13 -
6. Temperature data storage.
*
Make sure to press any keys until you hear an audible beep.
• To return to the standard measurement mode or the continuous measurement
mode from the data storage mode,
To standard measurement mode: Release
MEAS
key to move to the hold mode
To continuous measurement mode: Press
MEAS
key again to move to the hold
mode.
In the hold mode, press
MEM
key.
When the " " mark under the main marker "
MEM
" goes off, the mode
returns to the standard measurement mode or the continuous measurement mode
．
R e m a r k s
•
On this condition, by pressing
SEL
key, "
ε
" will be displayed in the sub marker
and the emissivity rate will be displayed in the sub display.
• The emissivity rate displayed is the emissivity rate set in [5.4 Emissivity rate
setting] or 1.000 (initial) if not set.
• The measured data stored in the specific data storage number can be recalled by
[(2) Specific data storage number setting]. (Ref. [6.2.2 Recalling of stored data])
R e m a r k s
• For changing the emissivity rate at the above ,
For the standard measurement mode, release
MEAS
key to move to the hold
mode
For the continuous measurement mode, press
MEAS
key again to move to the
hold mode.
Referring to [5.4 Emissivity rate setting], set a new emissivity rate by pressing
△
,
▽
and
ENT
keys in the hold mode.
• The new emissivity rate set will be effective from the next data storage number.
When you change the emissivity rate at the specific data storage number, follow
this procedure.
Reference1
R e m a r k s
(1)
Initial data storage number: The initial data storage number starts from "
1
".
(2)
Specific data storage number setting: The specific data storage number for the
next data storage can be set by pressing
△
,
▽
and
ENT
keys in the hold
mode. (Ref: [6.2.1 Data storage number setting])
Reference
• On the condition that the measured data stored in the specific data storage
number is being displayed in the main display, if you press
MEAS
key to
measure and then press
ENT
key, be careful that the measured data already
stored will be overwritten by a new measured data.
• If you do not want to overwrite, follow the procedures shown in [6.2.1 Data
storage number setting].
Caution
• Measured data can be stored in the data storage number from No. 1 to No. 100,
but when a measured data is stored in the data storage No. 100, the memory
becomes in the memory full condition and new measured data can not be stored
even if
ENT
key is pressed after then. (Ref: [6.3 Memory full])
Caution
Reference1
