Optex PT-7LD, Instruction Manual

Page: 52 / 56

[Record measured temperature/ MEM. mode]
PT-U80 can store 35 temperature measurement data.
Perform the following steps.
After “CALL” is displayed on the sub-
display, “MEM” blinks on the display
and a memory No. lights up on the
sub-display. Then the temperature
value that had been displayed when
the /MEM./CAL button was
pressed is stored in memory.
After the data is stored, the mode is
changed to HOLD.
1
*If the number of stored data has exceeded the capacity, “FULL” lights up on LCD.
1 Press this button for 2
seconds or more while
the power is ON.
[Call temperature record/CALL mode]
“CALL” is displayed on the sub-
display, and then the latest stored
temperature data and the
corresponding memory No. are
displayed.
*Data cannot be called during the
continuous measurement mode.
1
When the memory No. is changed,
the corresponding temperature data
is displayed in order.
2
Press the MEASURE button to
terminate the CALL mode. Then, the
nor mal measurement mode is
restored.
3
1 Press this button for
less than 2 seconds
while the power is ON.
18
Recording Measurement Temperature
To the page that follows