ENGLISH
FRANÇAIS
DEUTSCH
IT
ALIANO
ESP
AÑOL
PORTUGUÊS
EN-4
4
Tilt the bracket about 45° and pass
through the wire.
In
Out
5
6
Open the wiring knockout.
To the right
To the left
Wiring knockout
Determine the horizontal direction (left or right) of
the detector before installing the bracket on the wall.
7
Knockout with 4 × 20 tapping screw (screwkit)
Open the Up-Down lock screw knockout for
connecting the bracket.
8
Wiring
hole
Wiring
sponge pad
In
Tighten screws 1 and 2 , adjust the bracket angle
(refer to 2-2), then tighten screw 3 .
Perform an area check. If re-adjustment is required,
loosen screw 3 and change the bracket angle.
After the adjustment is complete, tighten screw 3
again.
Out
1
4 × 20
screw
3 4 × 35
Up-Down
lock screw
2
4 × 20
screw
Adjustment
screw
9
Tighten the adjustment screw clockwise.
10
Wire to the terminal and install the main unit and
lens on the base.
11
Install the shaft cover into place.
