29
CNCjs is a full-featured web-based interface for CNC controllers running
, or
For a more complete introduction, see the
section of the CNCjs wiki page.
Software Setup
○ … and many more.
2. Install CNCjs by double clicking on the downloaded installer.
Software Usage
1. Launch CNCjs from your Start Menu / Application Dock
2. In the "Connection" widget.
○ Select the "Port" that is your X-Controller, or similar.
○ Set the "Baud rate" to 115200.
○ Click "Open"
3. The Console widget should output the current settings when
you connect. If not send the command "$$".
○ Make sure the GRBL Spindle RPM / Laser Output
Range set correctly.
$30=1000
Max spindle speed, RPM
$31=0
Min spindle speed, RPM
○ Enable
