23
Prepare Laser
5. Connect to you Motion Controller / X-Controller / GRBL Shield.
a. Next to devices select the appropriate port.
b. Insure that the correct device, shown here as "X-Carve (GRBL)", is selected.
6. Home your machine by clicking the
button. Tool-head / Laser will move to its home position.
7. Select the Move widget. (this button can usually be found at the bottom of the Cuts widget)
8. Move your toolhead / laser to it work position, where you would like to engrave.
a. Jog machine into position with the arrow buttons, adjusting the distance and speed as needed.
b. These buttons will allow you to jog the X-axis, Y-axis, Z-axis, and A-axis (if one is present).
c. Set Laser Height to 60mm above work area.