Opex Eagle Remittance Processor, Operator'S Manual

Page: 98 / 108

98
Eagle Operator Manual
OPEX Corporation
B.1. Outsorts
Reason Description
Double Feed Outsort
The gap between two sequential envelopes exiting
the feeder was smaller than the DOUBLE
OUTSORT GAP SIZE machine parameter.
Gap Too Small Outsort
The gap between two sequential envelopes exiting
the feeder was smaller than necessary to perform a
proper extraction. (See the Feed Gap Control
section of this document for more information.)
Short Outsort
The measured length of an envelope at the right
envelope OCS sensor was less than the Length
Minimum job parameter.
Long Outsort
The measured length of an envelope at the right
envelope OCS sensor was greater than the Length
Maximum job parameter.
Thin Outsort
The outsort TMD determined that average
thickness of an envelope was less than the full
envelope Average Thickness Low job parameter.
Thick Outsort
The outsort TMD determined that average
thickness of an envelope was greater than the full
envelope Average Thickness High job parameter.
Thick Change Outsort
The outsort TMD determined that the envelope had
a change in thickness that fell between the full
envelope Minimum Thickness Change and
Maximum Thickness Change job parameters.
Thick Peak Outsort
The outsort TMD determined that the envelope had
at least one thickness reading above the Thickness
Peak Threshold job parameter.
Invalid Thickness Data
Could be caused by the following outsort TMD
problems: null value too small, null value too large,
no valid readings, no valid readings after the
offsets were applied, TMD processing was not
completed on time.