Opera Nivel Pro, Operating Instructions Manual

Page: 15 / 28

Premature deactivation
Press and scroll on the slider control of the desired zone, until you get to if you
want to turn off the zone, or until the wanted cooking level.
4.16 Power management
system
The Power Management system distributes power between the available cooking
zones arranged in pairs (such as figures on the side), providing maximum power at a
cooking zone and automatically reducing the power available to the other one. The
display of the second cooking zone alternates, for a few seconds, the power of
cooking chosen and the limited power.
In certain circumstances, the Extra powerful setting function
may turn off automatically to protect the electronic components
inside the hob.
4.17 Heat-up time automatic This function preheats the burner on maximum power in order to bring it rapidly up to
the required temperature. After a given time interval, the power level returns
spontaneously to the established setting.
It may be switched on in any of the hotplates for all power settings except for setting
“9” where power is set at maximum all the time.
Activation
‡ Automatic cooking mode is activated on any idle hotplate.
‡ Choose the required continuous cooking level and hold it for 3 seconds.
‡ The activated heat up time automatic will be displayed through alternating between
and the selected continuous cooking level on the display. As soon as the
parboiling time is over, the preselected continuous cooking level is valid again.
‡ Once the time in the chart below expires, the function is switched off and
disappears. You can also switch the automatic cooking mode off anytime by
modifying power level.
Power setting
1 2 3 4 5 6 7 8
Max. power cooking time
(seconds)
40 72 120 176 256 432 120 192
4.18 Bridge With the bridge function two separate cooking zones with the same diameter and
equal power. The bridge function is available for cooking zones showing symbols:
Two cooking zones can be turned on at the same time and controlled with only one
operation
Activation
‡ Whether the two zones are working at a different level, whether they are at level 0,
simultaneously press anywhere on the slider controls of the zones.
‡ Now the two areas work together, the LEDs to the right of the corresponding
displays turn on. The level is shown on the display of the control zone, in the
meanwhile the controlled zone’s display turns off.
‡ When this function is active, you can set the timer, the LED lights on near both
displays of the zones.
x
If in 10 uninterrupted minutes no cookware is detected on one of the two elements,
the bridge function is automatically deactivated.
Deactivation
x
The end of the Function can be done by repeating the simultaneous selection of
both cooking elements (the same as activation).
x
If the function is deactivated while in operation, than both cooking elements go to
level and can then be set again.
12
OPERATION EN