ET 200X(L) Series Digital Gateway User Manual
21/78
Table 3-2-2 Definition of Signaling
Options
Definition
Q.SIG Channel Mapping
Sets logical or physical channel mapping. In logical channel mapping,
channels are mapped to 1-30.In physical channel mapping, channels are
mapped to 1-15,17-31,skipping the number used for the data channel,
Default is physical.
Enable Caller ID
Whether or not to use caller ID
PRI Dial Plan for Dialed Number
PRI Dialplan: The ISDN-level Type of Number (TON) or numbering plan,
used for the dialed number. Leaving this as ‘unknown’ (the default) works
for most cases. In some very unusual circumstances, you may need to
set this to; ’dynamic’ or ‘redundant’
PRI Dial Plan for Dialing Number
PRI Local Dialplan: Only RARELY used for PRI(sets the calling number’s
numbering plan).In North America, the typical use is sending the 10 digit;
caller ID number and setting the prilocaldialplan to ‘national’ (the
default).Only VERY rarely will you need to change this.
Network Specific Facility (NSF)
Messages
Some switches (AT&T especially) require network specific facility IE.
Supported values are currently ‘none’, ’sdn’, ’megacom’, ’
tollfreemgacom’, ’ account’
Idle Bearer Reset
Whether or not to reset unused B channels
Idle Bearer Reset Period
Sets the time in seconds between restart of unused B channels; defaults
to ‘never’
Display Send
Send/receive ISDN display IE options, the display options are a comma
separated list of the following options:
block
: Do not pass display text data.
