Opengear 9450GT, Product Manual

Page: 44 / 50

4-16
••••
Configuration Fiber Ethernet Switch Transceivers Product Manual
(Product Manual)
Alarm Enable Tab
Table 4.6 summarizes the Alarm setup options available in DashBoard.
Note
— The number of sub-tabs, RJ45 Link check boxes, and Fiber Link check
boxes in the Alarm Enable tab is dependent on your card model.
Table 4.6 Alarm Enable Menu Items
Menu Title Item Parameters Description
Selected*
Enables the corresponding RJ45 Link
Status field in the Signal tab to report
when the specified ethernet port on the
rear module loses network connection
RJ45 # Link fails
Cleared Disables this alarm for the specified port
Selected*
Enables the corresponding Fiber Link
Status field in the Signal tab to report
when the specified fiber port loses
network connection
Fiber # Link fails
Cleared Disables this alarm for the specified port
Selected*
Enables the Internal Link Status field in
the Signal tab to report when the GigE
connection to the OG3-FR midplane
experiences an error condition
Internal Link Fails
Cleared Disables this alarm
Selected*
The HW Status field in the Hardware tab
reports when an unsupported rear module
is installed with the card
Switch
Incompatible Rear
Module
Cleared Disables this alarm
Selected*
The applicable Optical Module
Temperature field in the Signal tab reports
when the temperature of the SFP module
is not in range (high/low)
Fiber # Abnormal
Temperature
Cleared Disables this alarm for the specified port
Selected*
Enables you to configure the power
monitoring alarms for the specified fiber
port. Corresponding check boxes in the
tab are now editable.
Enable Fiber # Power
Monitoring
Cleared
Disables all monitoring of power
consumption on the specified port. The
corresponding check boxes on this tab are
now read-only.
Selected*
Enables the corresponding Optical Tx
Power field in the Signal tab to report
when the optical transmit power of the
Optical Module reaches
X#dBm
Fiber #
TX Power High
Cleared Disables this alarm for the specified port