OP BC 800/W ES SP, Use And Maintenance Manual

Page: 17 / 81

OP
S.r.l.
25131 BRESCIA - Via Serpente, 97 - Tel. 030/3580401 - Fax 0303580838
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
17
PRELIMINARY CHECKS AND START-UP
1) Make sure the quantity of testing fluid in the tank is enough while checking the relative
level indicator; otherwise, see to the refill as explained in the following procedure:
How to fill up with testing fluid
• Remove the side panel
• Remove the cap shown in the picture below and fill up the tank with the fluid
• Put the cap back in its position.
•
Put the side panel back in its position and fix it using the screws on the panel.
2) Make sure that the power supply is correct and connect the plug (pic. 3 item 01);
3) Connect the test bench to the air supply (pic. 3 item 02). For optimum bench operation,
the air flow-rate available must be of 1500 Nlt/min, with a pressure of 8 bar and the
pneumatic part of the circuit must always be pressurised.
1
2