OP BC 800/W ES SP, Use And Maintenance Manual

Page: 14 / 81

OP
S.r.l.
25131 BRESCIA - Via Serpente, 97 - Tel. 030/3580401 - Fax 0303580838
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
14
ROUTINE MAINTENANCE – GENERAL REGULATIONS
WARNING :
Always remove the plug from the socket, before performing any work on the
machine.
• It is important for all operations on the machine to be carried out by qualified, authorised
personnel, familiar with its functions.
• Never perform any operations of cleaning, lubrication or maintenance with the machine in
motion.
• We recommend wearing safety apparel such as non-skid footwear, earplugs, goggles,
suitable gloves, etc.
• After terminating all operations, always re-mount any guards removed before starting the
machine.
• For best results in operation of the booster pump, it is essential to use filtered but not
lubricated air; the test bench is equipped with an air preparation unit, located just past the
compressed air intake outlet, this unit must be kept constantly under control (for lubrication
of the pneumatic parts we recommend using oil TELLUS SHELL 22 or the equivalent). The
regulator of this unit has already been calibrated by O+P , for safety reasons;
any
readjustment could jeopardise proper operation of the test bench or create a hazardous
situation.
• Periodically, clean or replace, if necessary, the filters for the system fluid; the drain filter is
mounted on the lid of the tank. Loosen the fastening screws to access it, remove the lid on
the filter and take the filter cartridges out. The system is provided with two additional filters,
immersed in the tank, mounted on the pump intake circuit; to clean them, take the lid off
the tank. The filters have a filtration power of 60
 in intake and 25 µ on outlet.
• Replace the fluid filter, located over the tank (see pneumohydraulic diagram, position 3),
every two or three months or as necessary.
• Check and replace the fluid (CUT-MAX H 05 5) for testing when it becomes too polluted. A
drain tap is located on the side of the tank.
• Frequently check the conditions of the emergency stop on the control panel and safety
devices for closure of the tank door.
• For any operations of maintenance on the booster pump, see the enclosed instruction
manual.
SPARE PARTS
Accessories, spare parts or consumable materials must be ordered from O+P, always
specifying the serial number and model; these data will be found on the test bench nameplate.
Contact our sales office for detailed information.