ACK21-01A
ontracactuators.com
59
Setup in deactive password protection
mode without password verifying."88"
is the default password, the password
input is the same as in menu P6.1
Input feature setup
BE1 input setting
The two digits on left side of “_” in the value area are the function code. The actuator
has four switching value input ports BE1~BE4, and each port can be arbitrarily set
to one of the nine functions of “01” ~ “09” function (see the table below), The right
side of “_” can be set to “0” or “1”, “0” represents low level when the contact is not
triggered, and “1” presents high level when the contact is not triggered. Set the
function with and set the trigger mode with .
When actuator has output point set
to intermediate valve position
showing “1” or “2” ,then entering
P7.5, P7.6 in the menu for
intermediate valve position
BE2 input setting
BE3 input setting
BE4 input setting
Intermediate valve
position indication 1
Intermediate valve
position indication 2
01 Operation command in “OPEN” direction
02 Operation command in “CLOSE” direction
03 Shutdown command
04 Alarm reset command
05 Allowed to open command
06 Allowed to close command
07 Local control panel lock command
08 Remote analog/digital control switch command
09 ESD command
10 Fast running (1.4 times setting speed)
MODE
Short
Press
If you would like to set up password-protection, please set the P6.3, and then set
the P6.2, if you can not set the P6.3, password-protection may already active.
If actuator is set for deactive password protection as default (without password
protection), if protection has been activated, you would like to deactivate, enter P6.1
for your password verifying, then it can be saved.
ESD means Emergency
Shutdown System in
accordance with the principles
of independent security level,
higher than the DCS system
