-14-
The position of the relay after a power failure
If there is a power failure and the relay is activated, it will change to deactivated position.
When the power returns it will remember the position it had before the power failure.
If this is not desired, please set DIP-switch 8 to position ON.
Alarm
Ontech GSM 9020 can alarm in many different ways. All alarms are sent as SMS to the
telephone numbers on the alarm list (see page 7).
The unit can be programmed so the relay activates when there is an alarm, see page17.
Wired alarm
Two alarm inputs where alarm detectors can be connected. Can be set as
Normally Open
(NO)
or
Normally Closed (NC).
Wireless alarm
In the year 2009 Ondico AB will start to sell different wireless alarm units which
communicate with Ontech 9020. Up to 7 different alarm detectors can be connected.
The wireless alarm detectors planned are A. Motion detector, B. Magnet switch/Alarm
box and C. Emergency Alarm button. Also a remote control to turn on/off the alarm will
be offered.
Temperature alarm
The temperature alarm is trigged if the temperature rises above or drops below the
preset alarm temperature. See page 20.
GPS alarm
If a GPS receiver is connected the unit can be set to alarm if it is moved a preset number
of meters from its original position. See page 24.
Battery alarm
The unit alarms if the battery needs to be charged or if the battery is empty.
Power failure alarm
If an internal backup battery is connected the unit will alarm if the main power failures. A
delay of this alarm can be set to up to 40 minutes. See page 26.
