36
Programming remote controller codes
1. Set the A/B-SUB ROOM/LEARN selector switch to
LEARN.
2. Place the head of your old remote controller 2-4 inches
(5-10 cm) from the head of the RC-374M, laying both
units on a table or a flat surface.
3. On the RC-374M, press the button in the PROGRAM-
MABLE AREA into which you want to store the code.
•
The SENDING/LEARNED indicator lights up.
4. On your old remote controller, hold down the button
for the function you want the RC-374M to memorize
while the LEARNED indicator is lit. Keep pressing
this button until it turns off.
•
To store a code to another button, repeat steps 3-4.
NOTES:
•
Some remote controllers use a single button to perform
different functions, with the function code changing each
time the button is pressed. If you are using this kind of
controller, please perform the “learn” operations for each
function individually to store each function to a button on
the RC-374M.
•
For instructions regarding the operation of “learned” units,
please refer to the instruction manual for each product.
•
Even after codes have been memorized, please keep your
old remote controller in a safe place. If the memorized
codes are lost when the batteries run down, it will be nec-
essary to memorize them once again using the old remote
controller.
Reprogramming the buttons:
Follow the steps 1-4 described above. The previous codes
will be lost, and new codes will be stored.
Please check whether previously-memorized functions are
working properly. If the SENDING indicator is not illumi-
nated when a programmed button is pressed, it may need to
be relearned from your old remote controller.
Set the A/B-SUB ROOM/LEARN selector switch to the A
position.
Then operate the remote controller by pressing the buttons of
the functions you want to use.
•
If you press a button that has no code stored, the SEND-
ING/LEARNED indicator will not light up.
1. Set the A/B-SUB ROOM/LEARN selector switch to
LEARN.
2. Press and hold the POWER and VOLUME
†
buttons
together until the SENDING/LEARNRED indicator
turns off.
•
All codes stored in the programmable area will be
deleted.
Leaning new controller codes
Operating the RC-374M
Clearing all memorized codes
Switch to LEARN
POWER
SLEEP
DIMMER
TEST
TONE
SENDING/
LEARNED
LEARN
SUBROOM
A B
SUR
MODE
2
3
4
Light
5 to 10 cm
(2 to 4 inch)
The button you wish to memorize
RC-374M
1
Switch to A
POWER
SLEEP
DIMMER
TEST
TONE
SENDING/
LEARNED
LEARN
SUBROOM
A B
SUR
MODE
1
2
POWER
SLEEP
TAPE-1
TUNER
PHONO
C D
DIMMER
TAPE-2
SENDING/
LEARNED
LEARN
SUBROOM
A B
MULTI-CH
INPUT
REMOTE CONTROLLER
SUR.
MODE
DVD
VIDEO-1
VIDEO-2
SOURCE SELECTOR
PAUSE
/STEP
VOLUME
MUTING
/REMOTE
SPEAKER
LEVEL
CH SEL
TEST
TONE
RC-374M
SUR
MODE
