53
Enjoying Surround Sound
—Continued
Set the distance from the listening position to the speak-
ers.
With the distance set, the DVD receiver can keep con-
stant the time to deliver the sound from each speaker to
the listening position, thus providing more comfortable
sound environment for movies and music. The settings
are stored even when the DVD receiver is in the Standby
mode.
For adjusting the sound balance, set the sound level for
each speaker so that you may hear an equivalent sound
volume of the test tone from each speaker.
Adjusting Speakers with TEST TONE
You can take a shortcut for step 10 to 12 by following the
direct steps below.
Setting Distance of Speakers
7
Press
to select “2.Distance,”
and then press ENTER.
Press DISPLAY to switch between feet
and meters.
8
Select a speaker using
/
, and
set a distance using
/
.
You need to set the distance from the lis-
tening position to the L/R front speakers.
You can set up to 9.0 m (30 ft) by an
increment of 0.3 m (1 ft).
The Center and Subwoofer distances can
be set between 1.5 m (5 ft) more or less
than the Front distance.
The Surround speakers' distances can be
set up to 1.5 m (5 ft) more and 4.5 m (15
ft) less than the Front distance.
9
Press RETURN.
Returns to the display shown in step 7.
Then go to “Speaker Level Calibration”.
Speaker Level Calibration
10
Press
to select “3.Level Cal,”
and then press ENTER.
You may hear the burst of noise for the
test tone from the left front speaker.
11
Select a speaker using
/
, and
set volume using
/
.
You can adjust the tone within a range
between –12 dB and +12 dB (–15 dB to
+12 dB for the subwoofer).
The test tone will be output according to
the number of the channels you set for
the speakers in the previous page.
• If you set “No” for a subwoofer, the
test tone will not be output from it.
Note:
If you have set the sound level greater
than as usual, return it by using VOL-
UME– (minus).
12
Press RETURN.
Returns to the display shown in step 10.
To exit the speaker setting, press it once again.
You can also exit the setting by pressing
“RCV SETUP”.
1
Press TEST TONE.
Adjust the sound level with /–,
if necessary.
2
Switch over the speaker with CH
SEL, and then adjust the test tone
with /
.
The test tone will be switched over to the
next speaker in 2 seconds, even if you do
not press CH SEL.
3
Press TEST TONE.
That exits the setting.
Summary of Contents for DR-815
Page 83: ...83 Memo...
