Battery Considerations
24
ONePlus UPS User Instruction Manual
• Do not lay tools or metal parts on the battery.
WARNING:DO NOT attempt to change battery
wiring or connectors. Doing so can cause injury.
WARNING:Replace batteries with the same type
and quantity as previously installed in the unit.
WARNING:DO NOT disconnect the batteries if the
UPS is in battery mode.
Battery Replacement
Procedures
1. Remove plastic bezel from the front of the UPS
by pulling the top left corner forward and sliding
the front panel off (see fig. 9).
fig. 9: Removing the Front Panel
2. Remove the metal battery retention plate to
access the battery by removing the coin slot
screw(s) and sliding the plate up (see fig. 10).
fig. 10: Removing the Metal Cover
3. Disconnect the keyed wire connector which
connects the cable to the battery.
4. Carefully slide old battery out of battery
chamber onto a flat, stable surface (see fig. 11).
CAUTION:Be sure battery is supported when
removed from battery chamber.
ONePlus 250 & 400 VA models
ONePlus 600 & 1000 VA models
ONePlus 250 & 400 VA models
ONePlus 600 & 1000 VA models
