One World Touch MP1200, Service Manual

Page: 97 / 110

Service Manual version 1008
MP1200/MP1500 (PC920 Intel 945G)
7-89
7.4.5.3. SuperIO Device
If the SuperIO Device option is selected from the Integrated Peripherals menu, the screen below
will appear.

Power On Function
This function allows you to set the method by which your system can be turned on. Normally, it should
be set as Button Only so that your system will only start up if you use the button/switch on the casing.
Other alternative options including starting up the system using the keyboard (if it supports the
Keyboard 98 standard), a keyboard hot key (for other standard keyboards) or the mouse.

KB Power On Password
This item can be used to prompt a password when the system power is resumed by keyboard action.

Hot Key Power On
This item can be used to prompt a hot key when the system power is resumed by keyboard action.

Onboard Serial Port 1/Port 2/Port 3/Port 4
This item is to select an address for the serial ports.
The options are 3F8/2F8/3E8/2E8, Disabled.

Onboard UART 1/ UART 2/ UART 3/ UART 4 IRQ
This item is to select an IRQ for the serial ports.
The options are IRQ4/IRQ3/IRQ10/IRQ11/IRQ9/IRQ5,

COM2 Selectable type
：
This item is to select the COM2 port type
The options are RS232/RS422/RS485.

Onboard Parallel Port 1
：
This item allows you to determine the onboard parallel port controller’s I/O address and parallel port
mode.
The options are 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disable.
The options are SPP, EPP, ECP, ECP+EPP, Normal.
Phoenix – AwardBIOS CMOS Setup Utility
SuperIO Device
POWER ON Function [BUTTON INLY] Item Help
X KB Power ON Password Enter Menu Level

X Hot Key Power ON Ctrl-F1
Onboard Serial Port 1 [3F8]
Onboard UART 1 IRQ [IRQ4]
COM2 Selectable Type [RS232]
Onboard Serial Port 2 [2F8]
Onboard UART 2 IRQ [IRQ3]
Onboard Serial Port 3 [3E8]
Onboard UART 3 IRQ [IRQ10]
Onboard Serial Port 4 [2E8]
Onboard UART 4 IRQ [IRQ11]
Serial Port 4 Mode [Normal]
X IR Duplex mode Half
X Use IR Pins IR-Rx2Tx2
Onboard Parallel Port 1 [378/IRQ7]
Parallel Port 1 Mode [SPP]
X EPP1 Mode Select EPP1.7
X ECP1 Mode Use DMA 3
DIO Port Address [200]
↑ ↓ →
Move Enter
：
/-/PU/PD
：
Value F10
：
Save ESC
：
Exit F1
：
General Help
F5 ： PreviousValues F6 ： Fail-Safe Default F7 ： Optimized Defaults