STAND: 17.06.2019
9910_Operation_Manual_STANDCONTROL_C1_Rev1v1_EN
Seite 27 von 41
5. Confirm the input by once again pressing the “Logo” key.
6. The menu is exited automatically and
is displayed. This code requests an initialization.
Perform this according to the instructions in Section 8.4.
If no selection is made, after six seconds, the display will automatically return tot he main menu.
10.1.7 Set shelf and container stop (depending on the configuration)
Warning:
Only trained personnel should carry out the setting of container and
shelf stops. There is a danger of injury from wrong setting of the Stop positions,
and a danger of the table getting destroyed.
Warning:
With an initialisation movement prompted by the controller, the reset position
is always taken up directly. Any container stop or safety stop that is present is ignored.
First, remove all hindrances below the table (for example, Rollcontainer) and
pay heed to the increased risk of injury.
Note:
This menu option is not present in all controller configurations. If the menu
option is missing, the user is not allowed to set a container stop or a shelf stop.
Note:
With the additional stops, the safety of the table system can be increased,
in that the possible movement path is restricted.
Container- and shelf stops are safety positions that cannot be run over during normal operation, so
that collisions with known, permanently present hindrances can be prevented. The container stop lim-
its the movement height downwards (minimum height) and can be used if there are limiting factors
below the table, for example, a Rollcontainer. The shelf stop limits the movement height of the table
upward. The shelf stop can be used if there are limiting factors above the table, such as a shelf or the
incline of a roof.
To set a container stop or a shelf stop, proceed as follows:
1. Use the arrow keys ( and ) to move to the desired position.
2. Go to the menu of the hand switch in accordance with the instructions.
3. If necessary, navigate with the arrow keys ( and ) to menu option 4. The display must
show
.
4. Confirm the selection by once again pressing the “Logo” key.
5. Now select:
a. Press , to set the shelf stop (upper stop).
b. Press , to set the container stop (lower stop).
6. Confirm the input by once again pressing the “Logo” key. Alternatively, wait for approx.
6 seconds.
7. You are once again in the main menu and can make further settings.
The setting is permanently saved in the controller and is retained even when the hand switch is
replaced.
