STAND: 17.06.2019
9910_Operation_Manual_STANDCONTROL_C1_Rev1v1_EN
Seite 15 von 41
3. Drill the marked places for the screws with the drilling machine if necessary.
4. Fasten the STAND.CONTROL C1 with the two screws.
7.2.2 Assembly with controller bracket (FREE.STAND 9051)
Figure 2: Controller bracket for desktop FREE.STAND 9051.
No additional tool is required for fitting the controller with controller brackets. Two controller brackets
are required for every controller to be fitted. For fitting controllers using controller brackets, follow the
procedure below:
1. Fit the two controller brackets, as shown below, in the keyhole in the chassis beams. Turn
them 90° in a clockwise direction.
Note:
Ensure that the grooves for the cable routing are on one side, so that the cables
can later be routed past the STAND.CONTROL C1.
Figure 3: Installation of the controller brackets between the chassis beams of the desktop support frame.
2. Now position the latches of the bracket on the two holes of the motor controller on the rear
side, and latch the bracket with moderate pressure on both the components on the controller
(see Figure 4).
90°
