F-106
Long-life Two-circuit Limit Switch
WLM
@
Accessories
Cable
Installation
Item
Appropriate model/actuator
Details
Changing the installation position of
the actuator
By loosening the Allen-head bolt on the
actuator lever, the position of the actua-
tor can be set anywhere within 360
°
.
With Lamp-equipped Switches, the ac-
tuator lever comes in contact with the
top of the lamp cover, so use caution
when rotating and setting the lever.
Roller Levers: WLMCA2
@
, WLMH2
@
,
WLMG2
@
, WLMGCA2
@
Installing the roller on the inside
By installing the roller lever in the oppo-
site direction, the roller can be installed
on the inside. (Set so that operation can
be completed within a 180
°
level
range.)
Roller Levers: WLMCA2
@
, WLMH2
@
,
WLMG2
@
, WLMGCA2
@
Changing the orientation of the head
By removing the screws in the four cor-
ners of the Head, the Head can be set
in any of the four directions. Be sure to
change the plunger for internal opera-
tions at the same time. (The operational
plunger does not need to be changed
on overtravel general-purpose and
overtravel high-sensitivity models.)
Roller Levers: WLMCA2
@
, WLMH2
@
,
WLMG2
@
, WLMGCA2
@
Changing the operating direction
By removing the Head on models which
can operate on one-side, and then
changing the direction of the operation-
al plunger, one of three operating direc-
tions can be selected.
The tightening torque for the screws on
the Head is 0.78 to 0.88 N·m.
Roller Levers: WLMGCA2
@
Straight
5 dia.
5 dia.
14.9 dia.
6 dia.
DC
AC
Loosen the M5
×
12 bolt, set the
actuator's position and then
tighten the bolt again.
Loosen the
Allen head bolt
Head
Loosen the screws
Loosen the
screws
Head
The output of the
Switch will be changed,
regardless of which
direction the lever is
pushed.
The output of the
Switch will only be
changed when the lever
is pushed in one
direction.
Operating
Operating
Operating
Operating
Not operating
Not operating
Operational
plunger
Operation in both
directions
Clockwise operation
Anti-clockwise
operation