Omron V670 Series, User Manual

Page: 107 / 143

7-5
•
Holding in your hand
• Panel installation
To install a panel, use a mounting bracket Type C200H-ATT01 (unbundled).
(Unit: mm) When you install the panel, take the cable height into consideration.
When you use this unit in a control panel etc., keep the ambient temperature within 0 and 45 ° C.
Correct Usage
•
Do not attach a key holder etc. to the mode change key switch. Oth-
erwise, it becomes hard to operate the key pad.
•
You can pull out the mode change key when it is positioned at RUN
or MONITOR. You cannot pull of the mode change key, when it is
positioned at PROGRAM.
•
In the V670 Series, the PROGRAM mode is not used. Do not posi-
tion the key at PROGRAM when you use the V670 Series.
•
To reduce the buzzer sound when you press the key pad, set the
lever at the side face of the programming console to an upper posi-
tion.
•
When you disconnect the connecting cable from the programming
console, nip the levers at the both sides of the connector and then
pull out it.
Mounting bracket
Two screws
Applicable panel thickness
11.0 to 3.2
Mounting hole dimension
Standard panel cut is as fol-
lows (based on DIN43700):
Approximately 50 mm
Use either connector.
Approximately 70 mm
If you attach a key holder, it becomes
hard to operate the key pad.
You can pull out the key.
You cannot pull out the key.
Buzzer sound small
Buzzer sound large
7-4 How to Use