Omron Sti H-T40M-P, Installation And Operating Manual

Page: 14 / 21

N A V I G A T I N G T H E S C R E E N S
1 2
14
H-T40
M
-P Manual Rev.A
12 N
AVIGATING THE
S
CREENS
12
12.1. M
AIN
S
CREEN
- D
EFAULT SCREEN
Communicating Light: This light will blink when the status display
touchscreen is connected to the G9SP. If this light is not blinking, check the
G9SP power and/or cable connection.
12.1.1
Z
ONES
The zones allow the user to quickly see if a particular zone is in a run or
stop mode. Using the zone function with the G9SP requires the
programming of the optional communication transmission output bits in
the G9SP configurator software. The status of up to four zones can be
displayed.
The optional communication transmission bits are located at the bottom
left corner of the G9SP configurator software under the I/O Tag List, under
the Output tab. If the G9SP optional output communication bit is high
(on) the display will display “RUN”. If the bit is low (off) the display will
display “STOP”.
Figure 12-1 Main Screen - Default Screen