S8V-CP
12
Stripping length
Applicable to all the terminal blocks
Power input terminal block
Input Voltage
• The S8V-CP0424S provides over voltage tripping function. All
outputs will be tripped if the input voltage exceeds 28.8 VDC.
However, this function does not protect loads and internal parts
from high voltages in all cases.
Use the input voltage within the rated range.
• The S8V-CP0424S may operate the over voltage tripping for loads
that generate reverse peak electromotive force.
• The S8V-CP operates by DC input. Do not connect an AC power
source to the power input terminal.
Input Power Supply Selection
• Depending on the overcurrent protection characteristics of the
power supply connected to the input side can cause the failure of
S8V-CP operating or tripping by voltage drop occasionally.
• If the input power supply starts or stops too slowly, the overcurrent
protection characteristics of the power supply can cause the failure
of S8V-CP operating or tripping by voltage drop occasionally.
Tripping Performance
• Always remove the cause of the output first and then reset the
alarm when current tripping operates.
• When using a load that operates with constant power, the current
may be tripping when the power is turned OFF.
• Do not repeat the tripping and reset operations more than
necessary. Internal parts may possibly deteriorate or be damaged.
• Tripping performance depends on the ambient operating
temperature. Use the Product within the derating curve (see
Derating Curves
on page 7).
• Internal parts may possibly deteriorate or be damaged. Do not use
the Product for applications with frequent inrush current or
overloading at the load end.
Dielectric Strength Test
• Always short the all terminals of the Product so that the voltage is
applied at the same time.
• There is no insulation between the power input terminal and the
output terminal. Do not perform dielectric strength tests or other
insulation appraisal testing between inputs and outputs.
Connecting the S8V-CP
It is possible to connect multiple units of this Product as shown below.
Serial connections, such as connecting an S8V-CP to the output
terminal of another S8V-CP, can not be established.
Do not establish a parallel connection with other outputs. Also, do not
establish a parallel connection between the output terminals of two
S8V-CP.
Rated output current selector switch
The rated output current selector switch may possibly become
damaged. Do not apply more than the required force.
Recommended Wire Type
Stripping length
(Ferrules not used)
0.25 to 2.5 mm
2
/AWG 24 to 14
10 mm
Recommended Wire Type
Stripping length
(Ferrules not used)
4 to 6 mm
2
/AWG 12 to 10
15 mm
+V
+V
+V
+V
+V
-V
-V
-V
POWER SUPPLY
S8V-CP
S8V-CP
+V
S8V-CP
S8V-CP
+V
+V
-V
-V
+V
-V
POWER SUPPLY
S8V-CP
S8V-CP
S8V-CP
+V
+V
+V
-V
-V
+V
+V
+V
-V
+V
+V
-V
-V
POWER SUPPLY
POWER SUPPLY
