Omron NYB17-*100 SERIES, User Manual

Page: 147 / 194

5
Press and hold the UPS power button until On appears on the UPS display.
6
Power ON the Box PC and then wait until the device drivers are successfully installed.
7
Configure the UPS using the UPS Settings Utility.
8
Install the Simple Shutdown Utility.
9
Configure the Simple Shutdown Utility.
10
Configure the Box PC to auto-start after power loss within the BIOS settings.
• Refer to
A-1-1 BIOS Overview on page A - 2 for details on BIOS changes.
• Refer to A-1-5 BIOS - Boot on page A - 9 for power loss BIOS details.
11
Simulate a power interruption and confirm a correct shutdown of the Box PC.
• Start the Box PC
• Start applications
• Create a power interruption
• Monitor the shutdown sequence and confirm a correct shutdown sequence
The UPS is connected and configured.
The Box PC will shut down properly in case of a power supply interruption and restart automatically
when the power is restored.
Additional Information
• The default Input sensitivity setting is Standard voltage sensitivity and this is correct.
Do not set this parameter to Low voltage sensitivity . Doing so can cause a system malfunc-
tion when switching to battery mode.
• The UPS Setting Utility can not be used when the Simple Shutdown Software is active.
To use the UPS Setting Utility:
(1) Right-click the Simple Shutdown icon and select Agent Stop.
(2) Use the UPS Setting Utility.
(3) Right-click the Simple Shutdown icon and select Agent Start.
5 Installation
5 - 51
NY-series Industrial Box PC Without Operating System User's Manual (W586)
5-8 Connect UPS
5
5-8-1 Connect UPS Using the USB Connector