Omron NX701-1620, User Manual

Page: 71 / 168

2 - 7
2 System Configuration
NX-series CPU Unit Hardware User’s Manual (W535)
2-3
Network C
onf
igu
ratio
n
2
Connection Connection method
Sysmac Studio Use the built-in EtherNet/IP port.
Between Control-
lers NJ/NX-series Controller or CJ-series
PLC Use the built-in EtherNet/IP port or a port on an Eth-
erNet/IP Unit.
*1
*1. Use a CJ-series EtherNet/IP Unit with a unit version of 2.1 or later.
Also, mount the EtherNet/IP Unit to an NJ-series CPU Unit with unit version 1.01 or later, and use Sysmac
Studio version 1.02 or higher.
Refer to the
NJ/NX-series CPU Unit Software User’s Manual (Cat. No. W501) for information on version up-
grades.
Devices Servo Drives, general-purpose
slaves and Vision Systems Use the built-in EtherCAT port.
Ethernet communications devices Use the built-in EtherNet/IP port or a port on an Eth-
erNet/IP Unit.
*1
Serial communications devices
Mount a Serial Communications Unit
*2
and use
RS-232C port or RS-422A/485 ports.
*2. Mount to an NJ-series CPU Unit.
DeviceNet slaves
Mount a DeviceNet Unit
*2
and use DeviceNet.
CompoNet slaves
Mount a CompoNet Master Unit
*2
and use Com-
poNet.
Programmable Terminals Use the built-in EtherNet/IP port or a port on an Eth-
erNet/IP Unit.
*1
Servers Connections to BOOTP server, DNS
server, or NTP server Use the built-in EtherNet/IP port or a port on an Eth-
erNet/IP Unit.
*1