39
Sensor assembly
Section 6-2
The sensor must be fitted so that:
• It is correctly aligned before it is adjusted
• It is protected as far as possible against vibration and shock
• It is protected as far as possible against extraneous incident light
• It is protected as far as possible against damage and soiling
• Electrical connection is possible
• It is as accessible as far as possible for maintenance work
• Operation of the push buttons is possible
• The display is visible.
6-2-1
Sensor's assembly direction
As far as possible, the sensor's optical surface should be aligned parallel to
the surface of the measured object.
Figure 3 Parallel alignment
If the measured object has a glossy, reflecting surface, the sensor's
optical system should be tilted by 5 … 10° in relation to the surface of
the measured object.
Figure 4 Alignment for glossy surfaces
90°
90°
detection object
90°
5 … 10°
°
detection object
Summary of Contents for E3NT-L
