A-461
E3C-LDA Series
E3C-L
DA Series
Setting Method
Teaching With and Without a Workpiece
Teaching can be performed twice, once with and once without a workpiece, and the value between the two measured values is
set as the threshold.
I
If DIFF (differential operation) is set for the detection method, the threshold value will be set to half of the difference be-
tween the two measured values.
Setting Method
TECH
----
Switch to SET mode.
RUN
SET
The sub-display will flash.
Press the UP or DOWN key.
Press the UP or DOWN key for at least 3 seconds.
Threshold value
RFCT
• Setting Errors
RFCT
OVER
Flashes twice
Teaching completed and previous display returns.
The threshold value that was set will flash twice.
Do one of the following and then repeat the operation
•
Adjust the Head to decrease the incident light level.
•
Execute power tuning.
Threshold value
2PNT
TECH
----
Switch to SET mode.
RUN
SET
The sub-display will flash.
Teaching completed and previous display returns.
The incident light level with a workpiece will be measured and the previous display will return.
The threshold value that was set will flash twice.
Position a workpiece and press the
UP or DOWN key.
Remove the workpiece and press the UP or DOWN key.
Workpiece