Omron DA0271, Startup Manual

Page: 3 / 38

Introduction
The
NJ-series Startup Guide for Simulink® PLC Coder™ and Sysmac Studio
(hereinafter, may
be referred to as “this Guide”) describes the startup procedures that are required to use a
combination of Simulink® PLC Coder™ from The MathWorks® Inc. and NJ-series CPU Unit for
the first time and the basic operating instructions for the Sysmac Studio. A simple single-axis
positioning example is used for the discussion. You can perform the procedures that are
presented in this Guide to quickly gain a basic understanding of the combination of Simulink®
PLC Coder™ and NJ-series CPU Unit.
This Guide does not contain safety information and other details that are required for actual use.
Thoroughly read and understand the manuals for all of the devices that are used in this Guide
to ensure that the system is used safely. Review the entire contents of these materials,
including all safety precautions, precautions for safe use, and precautions for correct use.
Intended Audience
This guide is intended for the following personnel.
• Personnel in charge of introducing FA systems
• Personnel in charge of designing FA systems
The personnel must also have the following knowledge.
• Knowledge of electrical systems (an electrical engineer or the equivalent)
• Knowledge of MATLAB®/Simulink® from The MathWorks® Inc.
• Knowledge of NJ-series CPU Units
• Knowledge of operation procedure of Sysmac Studio
Applicable Products
This guide covers the following products.
• CPU Units of NJ-series Machine Automation Controllers
• Sysmac Studio Automation Software
• MATLAB®/Simulink® from The MathWorks® Inc.
• Simulink® PLC Coder™ from The MathWorks® Inc.
Special Information
The icons that are used in this Guide are described below.
Precautions for Correct Use
Precautions on what to do and what not to do to ensure proper operation and
performance.
Additional Information
Additional information to read as required.
This information is provided to increase understanding or make operation easier.
1