Omron CJ1W-CRM21, Operation Manual

Page: 59 / 172

CJ1W-PNT21 PROFINET IO Controller DTM Section 4-3
43
Master DTM Configuration User Interface
The IO Controller DTM Configuration User Interface contains five main items.
• PROFINET Identification
• Configuration
• Diagnosis
• Firmware
• DTM Information
The five items are discussed below.
Configuration Interface
Buttons The IO Controller DTM Configuration User Interface contains four general
buttons. The table below shows the name and the action for each button.
/i
!Caution
Changes made by the user are saved in the DTM only, and not in the Project. This is
indicated by the asterisk next to the DTM in the Network view. The next time in the
same session the GUI is opened, the changes will still be there. To save the changes
permanently, for example to hard disk, click the
File - Save
option from the main menu
of CX-ConfiguratorFDT.
4-3-2 PROFINET Identification
The PROFINET Identification item is used to detect and setup the names of
the PROFINET IO Devices on the network. The PROFINET Identification item
has only one sub-item:
• Network Scan
The sub-item is described in the section below.
4-3-2-1 Network Scan
In the Network Scan sub-item the following settings and operations must be
done prior to starting PROFINET IO Communication.
1 Acquire an overview of all IO Devices connected to the network.
2 Make the IO Devices or IO Controller LED’s flash to be able to identify the
Unit.
3 Set the Device Name for each of the IO Devices and IO Controllers
connected to the network.
It is required for the PC to have an Ethernet connection to the Network to perform these
operations.
The Network Scan screen is shown below.
Button Action
OK Evaluate, and save the changes made (if any) and close the user
interface.
Note: If any invalid settings have been made, a warning message
will be displayed, allowing cancellation of the command.
Cancel Closes the user interface without saving.
Note: If any changes were made, a warning message is displayed,
allowing cancellation of the command.
Apply Evaluate changes and save them.
Help Launch context sensitive Help for the Active tab.