Omnitron Systems OmniConverter 10G, User Manual

Page: 6 / 8

Page 11 Page 12
4) Connect Cables
a. Insert the SFP/SFP+ transceiver into the SFP receptacle on the front of the
module. Refer to the SFP or SFP+ data sheets for supported 1G and 10G
transceivers. The data sheets are available on the XFP, SFP+ and SFP
Transceiver product page at: www.omnitron-systems.com
NOTE: The release latch of the SFP fiber transceiver must be in the closed
(up) position before insertion.
b. Connect an appropriate multimode or single-mode fiber cable to the fiber port
on the front of the module. It is important to ensure that the transmit (TX) is
attached to the receive side of the transceiver at the other end and the receive
(RX) is attached to the transmit side. When using single-fiber (SF) models, the
TX wavelength must match the RX wavelength at the other end and the RX
wavelength must match the TX wavelength at the other end.
c. Connect the RJ-45 Ethernet port using the appropriate cable type for the speed
of the interface (see Specification Table) to an external Ethernet device. The
RJ-45 Ethernet ports support multi-rate speeds of 10Mbps, 100Mbps, 1Gbps,
2.5Gbps, 5Gbps and 10Gbps.
5) Verify Operation
Verify the module is operational by viewing the LED indicators.
Power LED Indicators
Legend Indicator Description
Pwr
OFF Unit not powered
Green - ON Unit powered
Power LED Indicators
Uplink Ports LED Indicators
Legend Indicator Description
Link
OFF Port Not Linked
Green - ON Port linked at the speed indicated by the Rate LED
Green - Blinking at 10Hz Port is transmitting or receiving data at the rate indicated
by the Rate LED
Rate
OFF No link
Green - one blink Port linked at 10M, 100M or 1G
Green - two blinks Port linked at 2.5G
Green - three blinks Port linked at 5G
Green - four blinks Port linked at 10G
When the uplink port is installed with an RJ-45 SFP+ transceiver, the LED will
indicate the speed of the connection as shown above.
Uplink Ports LED Indicators
RJ-45 Ports LED Indicators
Legend Indicator Description
Link
OFF Port Not Linked
Green - ON Port linked at the speed indicated by the Rate LED
Green - Blinking at 10Hz Port is transmitting or receiving data at the rate indicated
by the Rate LED
Rate
OFF No link
Green - one blink Port linked at 10M, 100M or 1G
Green - two blinks Port linked at 2.5G
Green - three blinks Port linked at 5G
Green - four blinks Port linked at 10G
RJ-45 LED Indicators