Page 7
2) Installing the Module
Wall Mounting
The wall mounting height of the module should be less than or equal to 2 meters
(6.6 feet) from the floor. Use the four mounting holes on the module to secure the
module to the wall. The module can accommodate #6 screws (not included).
Installation of the module should be such that the air flow in the front, back, side
and top vents of the module are not compromised or restricted.
The accessory cables should have their own strain relief and do not pull down on
the module.
Rack Mounting
The module can be rack mounted using the optional Rack Mount Shelf (8260-0).
Refer to the Rack Mount Shelf user manual (040-08260-001x) for the proper
installation guidelines. The user manual is available on the iConverter Rack Mount
Shelf product page at:
DIN-Rail Mounting
The module can be DIN-rail mounted using the optional DIN-rail Mounting Bracket
(8250-0) or the optional DIN-rail Mounting Clip (8251-0). Refer to the user manuals
(040-08250-001x or 040-08251-001x) for the proper installation guidelines.
Page 8
3) Apply Power
AC Power
Secure the ground wire to the ground screw. See the figure below for the location
of the grounding screws.
AC Models Rear View: Barrel Connector for AC/DC Power Adapter
Route the power cord through the provided strain relief for additional support and
connect the barrel or DIN connector (depending on the model) at the end of the wire
on the AC/DC adapter to the barrel or DIN connector on the module. Connect the
AC/DC adapter to the AC outlet. Confirm that the module has powered up properly
by checking the Power LED located on the front of the switch.
The AC power requirements for each port configuration is outlined in the table below.
Voltage ranges are inclusive of tolerances.
1 RJ-45 Port
100 to 240VAC, 50 to 60Hz
0.1A @ 120VAC
2.5 mm Barrel
2 RJ-45 Ports
100 to 240VAC, 50 to 60Hz
0.14A @ 120VAC
2.5 mm Barrel
Make sure to disconnect the power and ground cables before removing the module.
NEVER ATTEMPT TO OPEN THE CHASSIS OR
SERVICE THE POWER SUPPLY. OPENING THE
CHASSIS MAY CAUSE SERIOUS INJURY OR DEATH.
THERE ARE NO USER REPLACEABLE OR
SERVICEABLE PARTS IN THIS UNIT.
WARNING!!!
Summary of Contents for OmniConverter 10G
Page 8: ...Mechanical Page 15 Page 16...
