[email protected] | Installation manual Omnicomm 2.0 terminals v2.2
7
.16 | 20
6
INSTALLATION AND DISMANTLING
6.1 INSTALLATION OF THE OMNICOMM TERMINAL
1) The Omnicomm Terminal should be mounted inside the vehicle cabin or in specially designed
boxes of electrical equipment on the vehicle, protected from precipitation.
2) Omnicomm Terminal must be installed on a smooth surface. It is possible to install it on both
vertical and horizontal surfaces.
3) In order to maximise the e
ff
ectiveness of the built-in GSM and GLONASS / GPS antennas of the
Omnicomm Light 2.0 Terminal, it is recommended to
fi
x the position of the Terminal such that it is
as close as possible to horizontal, in a location with an e
ff
ective radio span of the sky.
4) Drill four Ø4 mm holes according to Figures 16 and 17.
FIGURE 16. INSTALLATION DIMENSIONS
OF THE OMNICOMM PROFI 2.0 TERMINAL
FIGURE 17. INSTALLATION DIMENSIONS
OF THE OMNICOMM OPTIM 2.0
AND OMNICOMM LIGHT 2.0 TERMINALS
5) Install the Omnicomm Terminal in the appropriate place of installation.
6) Secure Omnicomm Terminal on the surface with four self-driving screws.
6.2 INSTALLATION OF GLONASS/GPS ANTENNAS
When choosing the place of installation, verify the appropriate length of the antenna cable.
The antenna should be mounted on a metal surface. Glue adhesive is required for installation on a non-
metallic surface.
We recommend that you install the GLONASS/GPS antenna on the roof of the vehicle (Figure 18). You can
install the GLONASS / GPS antenna inside the vehicle, in a place with a satisfactory radio span of the sky.
When installing inside a vehicle, place on a level surface and be sure to check the quality of GLONASS / GPS
satellite signal reception.
When you install the antenna on the roof of the vehicle, the antenna must be protected from air currents when
driving, i.e. it must be installed under a protective visor or wind canopy on the roof of the vehicle.
