10
DM-R160-0427A (Rev 2)
www.omnexcontrols.com
call toll free: 1-800-663-8806
Tether connection detected
Low battery. Unit will run approximately 20 hours after Battery light starts flashing.
Power switch is stuck in the “UP” position
.
The Active light remain on momentarily when a function is activated (i.e. a switch or
paddle is triggered). This is normal operation.
Normal Operation
The transmitter is in Download Mode.
Normal Operation
The Active light will flash 2 times per second, indicating that the transmitter is sending
signals to the receiver.
Stuck switch detected. Ensure that all switches are in a centered position. The trans-
mitter will not power up when a function is ON.
On Power Up
Release the E-Stop button within 10 seconds to power up the transmitter, or the unit will
power down.
On Power Up
Press and release the E-Stop button within 10 seconds to power up the transmitter, or
the unit will power down.
The transmitter is in Calibration mode
STOP
STOP
STOP
STOP
STOP
STOP
STOP
STOP
STOP
STOP
Light Legend
Solid
Slow
Flash
Fast
Flash
Red
Light
Green
Light
Alternating Red
& Yellow Light
Yellow
Light
Diagnostics—T300 Transmitter
Status
Module 1
Module 2
Module 3
Module 4
Module 5
Module 6
Module 7
Status Indicator
Module is operating properly
Low battery condition detected
There is a fault with the module
Fuse blown
Communication to the module is active
STATUS
STATUS
STATUS
STATUS
STATUS
Module is installed and operating properly
There is a short to supply
There is a short to ground / over current
No Module installed
Module 1-7 Indicators
MODULE
MODULE
MODULE
MODULE
Indicator lights for the D180 Expansion Module
Diagnostics - D180 Expansion Module
