8
DM-R160-0427A (Rev 2)
www.omnexcontrols.com
call toll free: 1-800-663-8806
Light Legend
Solid
Slow
Flash
Fast
Flash
Red
Light
Green
Light
Alternating Red
& Green Light
Yellow
Light
A.
ESTOP
FAULT LINK STATUS
A. Supply power to the re-
ceiver. The (E-Stop) light
and the (Link) light will
come on RED and the
(Status) light will come on
GREEN
3. Power R160
A. Hold [Power] switch UP
B. Press [E-Stop]
C. Twist CW & release [E-Stop]
D. Release [Power] Switch
4. Power T300 into Configuration Mode
D.
NOTE: If left idle in Setup Mode for over 30 seconds, the receiver will time out. The (Link) light and (Status) light will flash RED rap-
idly. To return to Setup Mode, repeat step 5.
A. Press & hold [Setup] button
until (Status) light goes from
slow flash to fast flash
B. Release [Setup] button.
(Status) light goes to solid
GREEN, (Link) light turns off
ESTOP
FAULT LINK
STATUS
Setup
Button
A.
ESTOP
FAULT LINK STATUS
Setup
Button
B.
5. Put R160 into Setup Mode
6. Download ID Code
ESTOP
FAULT LINK STATUS
A. Press [Power] switch UP
and release
B. (Link) light goes to GREEN.
Once complete, (Link) light
goes to RED as the trans-
B.
B.
A.
C.
0
A.
NOTE: For this document, orientation
of the paddle and switch operation will
be defined as follows:
Paddle UP—is towards the switches
Paddle DOWN—is away from switches
Switch UP—is away from paddles
Switch DOWN—is towards the paddles.
UP
DOWN
Download ID Code
(Use in case of Link Test failure)
NOTE:
When downloading a new ID to a receiver, a safety feature requires that the transmitter be in close proximity to the receiver. This will pre-
vent a transmitter from accidentally reprogramming a different receiver in the area.
