18 |
P a g e
Viewing Chart Data
The Chart has several helpful feature to make viewing data easier. Move the mouse over any
data point to show the sensor reading for that data point. Click and drag on the chart to zoom
into a specific section. Click the
Reset Zoom
button to zoom out to the full extents. The
Save
Graph Data
button will save all of the points displayed on the graph to a comma separated
value (csv) file which is readable by most programs.
Note:
Data is lost after closing the chart page. Data older than the time span is lost
and will not be displayed on the chart. For long term data logging please use the
Omega Dashboard Software.
System Page
The ZW-REC System page is used to setup the Radio and Network parameters for the device
and to upgrade firmware. The administrator login is required for this page. Changes to these
settings could cause loss of connectivity to the webpages or the connected End Devices. Care
is advised when making any changes. Some settings on this page require a reboot to take
effect. The ZW-REC can be rebooted using the
Reboot ZW Receiver
button at the bottom on
the page.
Note:
For detailed instructions on upgrading firmware see
APPENDIX B
.
5.1 System Information
System information is displayed at the top of the
page. The current version on Baseboard and radio
firmware is listed as well as the PAN ID. The PAN ID
is similar to the Network ID and is used for setting
up UW Series End Devices.
Clicking on the information icon next to the PAN ID
brings up a DIP Switch configuration chart for
zSeries and zwSeries End Devices. This chart shows
which DIP switches need to be used to connect the
End Devices to the ZW-REC. Refer to the End Device
User Manual for more information on End Device
setup.
Figure 13. System Information
