Receiver Operation
8
13
Section 8 - Receiver Operation Cont.
Receiver Operation - UWTC-REC2-D-*-NEMA
Indicator Lights
(1) Transmit (TX) Green Indicator Light
The top green indicator light marked “TX” on the front of the receiver will
only blink when the receiver is connected to your PC and you initialize your
measurement software. After the receiver establishes communication with the
program the light will no longer blink. Note: this may happen very fast and
will not be noticeable.
(2) Receive (RX) Red Indicator Light
The red indicator light marked “RX” on the front of the receiver will blink
each time the receiver receives incoming data from one of your connector
transmitters.
(3) Standby (SB) Yellow Indicator Light
The yellow indicator light marked “SB” on the front
of the receiver will blink continuously during normal
operation. This indicates that the receiver is in the
“Standby” mode and is waiting for incoming data from
your connector/transmitter.
(4) Power (PWR) Green Indicator Light
Indicator Lights
1
2
SB
PWR
RX
TX
3
4
1
2
5
3
4
6
UWTC-REC2-D-*-NEMA
(1) Antenna
(2) USB NEMA 4X Connector Sealing
Cap
(3) USB NEMA 4X Connector Cable
(4) Indicator Lights
(5) 8 Pin Analog I/O
Waterproof Cable
*: V1, V2, MA Units.
Cable Configuration:
Green Wire: Analog Output (–)
White Wire: Analog Output (+)
Orange Wire: Alarm Power
Yellow Wire: Alarm Output
Blue Wire: Digital Ground
(6) 12 Vdc Power Apaptor
