Omega TRCN443, User Manual

Page: 17 / 26

While during Reading, press key and the instrument will go to , turning off the
alarm and control outputs.
<ENTER> STAND-BY
NOTE:
OMEGA
MOD:TRCN443 V1.0
DISPLAY TEST
»»»»»»»»»»»»»»»»
»»»»»»»»»»»»»»»»
S1:» S2:»
-> 0.0001 NTU
menus are self explanatory with its respective options, that are simply selected by pressing
key. After choosing the selection (flashing option), press key, to confirm
T
the slected option.
If a mistake occur or user desires to change option already chosen, press
, to go back to
prior step. At every touch the screen will move back one step back. While in Reading Mode,
key must be pressed and hold for about
< SELECT >
< ESCAPE >
SCAPE >
< ENTER >
<E 6 seconds to exit this mode and return to main
menu.
12.
Equipment Operation - Turning On
16
Interpreting the Read menu. The Set Points will be
displayed and by the box on the side of each
contact, user can find out the status of these
contacts.
Indicates that the contact is On and operating at
the moment.
Indicates that the contact is On but not operating
at the moment.
Indicates that this contact was set as Off
All contacts are programed during Set Up Mode.
Press <ESC> key and hold in order to exit the
Reading Mode and access the Main Menu.
X
TURBIDIMETER
/SET UP READ
Note A - Every time you see the symbols “ ” “ ”, that means that the user can
adjust the displayed value up or down.
To increase the value press
key until “ ” flashes, then press to
confirm, then press key and at every touch the value will increase by one
unit.
To decrease the value press
key until “ ” flashes, then press to
confirm, then press key and at every touch the value will decrease by one
unit.
If a mistake is made, press
key to return and correct the value!
>
>
and <
<
<SEL>
<SEL>
<SEL>
<SEL>
<ENT>
<ENT>
<ESC>