6
Remote Trunk Release & Carfinder
To Activate the Trunk Release:
Press & Release the lower right
transmitter button
OPERATE OPTIONAL
TRUNK RELEASE
To Activate Carfinder:
Press & Hold the upper left transmitter button
for 3 seconds
THE PARKING LIGHTS
WILL FLASH ONCE, THEN
SIX TIMES
*
*
35
Receiver Module:
An essential part of the RS-7K2 is the plug-in window mount Receiver Module. The
unit will not operate unless this Receiver Module is plugged-in. Select a desired
mounting location for the Receiver Module; optimum performance is obtained by
mounting this module high and unobstructed on the vehicle’s glass, such as the
windshield behind the rearview mirror. Make sure the glass surface is clean and
free of dust, grease, or debris. Peel the backing off of the adhesive tape and affix
the Receiver Module. Carefully route the module’s 3-wire ribbon cable to the RS
unit control module, and plug the cable into the Black 3-pin port on the rear of the
module.
Valet Switch:
Mount this switch in a location that’s easily accessible to the user. Route the wires
to the RS unit's control module and plug the 2-wire connector into the matching 2-
pin port on the control module. The Valet Switch is used to place the system into
Valet Mode, Features Programming Mode, and Transmitter Programing Mode. In
everyday operation, the “on” or “off” status of this switch controls Valet Mode. For
the two programming modes, this switched is toggled “on” and “off” within 7
seconds of the ignition switch being turned “On” (for transmitter programming
mode) or “Off” (for features programming mode).
Receiver Module & Valet Switch:
