Page - 7
Page - 10
Other Remote Start Features
Turbo Timer Feature
It is typically recommended that vehicles equipped with turbocharged
engines allow the engine to idle for a few minutes before turning it off.
When this Installer Programmable Feature is programmed on, the RS-
210-DP will automatically keep the engine running as follows:
•
With the engine running, hold the brake pedal and engage the parking
brake. When the brake pedal is released, the RS-210-DP will keep the
engine running for the selected time, and then automatically turn it off.
Step 7
Allow 10 seconds to pass without performing any programming
actions, or turn the vehicle’s ignition on.
• The Status Light & parking lights will turn off.
Change the Feature:
Step 5
After accessing the desired feature, within 10 seconds Press &
Release the brake pedal equal to the option desired.
• Pressing the brake pedal once typically turns the feature on; or sets the
feature’s first option. The Status Light and the parking lights will
flash once when this option is chosed.
• Pressing brake pedal twice also typically turns the feature off; or,
sets the feature’s second option. The Status Light and the parking lights will
flash twice.
• Many features have third, and even fourth setting options. Pressing the brake
pedal 3 or 4 times will select these options. Status Light & parking lights
flash three or four times respectively.
To Access and Change further Features:
Step 6
If there are more features to be programmed, within 10 seconds of
the previous action Press & Release the Valet Switch the same
number of times as the next desired feature’s number.
• Again the Status Light and parking lights will flash as many times as the Valet
Switch was pressed to indicate the new feature number which is now accessed.
Then press the brake pedal as described in
Step 5
to change the newly
accessed feature as desired.
The turbo timer feature must be programmed by the installer, and turn-
ing it on offers three run time choices- 1, 2, or 3 minutes. The system may
be locked while the engine is running. Turbo Timer can be prevented from
engaging, or “bypassed” if desired, by turning the engine off first and then
engaging the parking brake, or if it’s already engaged simply step on the
brake pedal to turn the running engine off.
The Status Light
The Status Light helps to visually confirms the status of the system and
provides a high level of visual deterrence. The Status Light is located in the
window mount receiver unit.
Normal System Status
2) On Constant = The system is in the Valet Mode, with the remote starter
system disabled.
1) Off = The system is unlocked and the remote starter system is off, but
in standby mode.
The User Programmable Features
- SEE PAGE 9 FOR PROGRAMMING INSTRUCTIONS -
Each of the Programmable Features is described in detail on the following
pages. The User Programmable Features are described as this first group,
and the Installer Programmable Features as a second group. Installer
Programmable Features should only be used by the original or other
qualified installer, AND individual Installer Features should only be used
with the correct wiring connections.
This group of User Programmable Features are all accessed as a group in the first
level of features’ programming. These features have a direct affect upon the
system’s operations, so the programming and operation of each are described.
Use the step-by-step instructions on page 9, and the complete features matrix on
page 15, to change any of the programmable features. Each feature, the option
choices and related programming transmitter button assignment are described in
detail in the following pages.
