background image

3

 

WARNINGS:  

1.

 

This appliance is not intended for use by persons (including children) with reduced  physical,  sensory  or mental 
capabilities,  or lack of experience or knowledge,  unless they have been given supervision  or  instruction 
concerning  the use of the appliance by a person  responsible for  their  safety.   Children should  be supervised  to 
ensure that they do not play with the appliance. 

2.

 

DO NOT USE OR STORE FLAMMABLE MATERIALS IN THE APPLIANC STORAGE DRAWER OR NEAR THIS 
APPLIANCE. DO NOT SPRAY AEROSOLS IN THE VACINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION. 

3.

 

DO NOT MODIFY THIS APPLIANCE. This appliance is not suitable for use with aftermarket lids or covers. 

4.

 

WHERE THIS APPLIANCE IS INSTALLED IN MARINE CRAFT OR IN CARAVANS, IT SHALL NOT BE USED AS A SPACE 
HEATER. 

5.

 

After  removing  the  packaging,  make sure to check if there is any damage to the appliance.  If there is  any 
damage, never attempt  to use the appliance and immediately  contact your  a uthorised Service  Centre.   As 
packaging materials can  be dangerous to  children, they need to be collected immediately and put out of reach.  

6.

 

In certain  circumstances electrical appliances may be a safety hazard.  The unit MUST be connected  to the 
electrical  supply before  operation  to enable the electronic ignition  to work.  The electrical connection  must be 
accessible after  installation. The appliance must  be electrically isolated before any maintenance can be performed. 

7.

 

Do not  place heavy  objects on this  appliance (cooktop or door), use for storage or as a cutting surface, as sharp 
edges can damage the surface. This appliance is designed for cooking only. If any damage such as chips 
or cracks are seen in the glass, turn off all control knobs and do not use until the appliance has been 
inspected by an authorised service person or replaced. 

8.

 

This appliance is designed for domestic household use only  and for the cooking  of domestic food products.  Use 
as a commercial appliance will  void  the  warranty.  It should not  to  be used outdoors and must  be fully installed. Do 
not use the appliance until fully installed. If this appliance is installed on a base, measures must be taken to prevent 
the appliance from slipping from the base. 

9.

 

Damage can occur to bench tops if pots and pans are able to overlap the bench top. This can result  in  heat 
being  transferred  to the bench top. Ensure that correct sized pots & pans are used. Refer to guide in 
instructions. 

10.

 

Do not  allow  pot  handles  or utensils to be placed  near gas burners in operation, as they  can cause the handles  to 
become hot to touch. Always turn handles away when small children are nearby. It is recommended that  children 
are kept  away from  the  cooktop at all times. 

11.

 

D o not  leave the cooktop  while  cooking  with  solid  or  liquid oils.   There may  be flaming up  in  conditions of 
extreme heating.  Never pour water onto the flames occurring from oil.  Immediately  turn the cooktop off and 
cover  the pan with  a lid or fire blanket  in order  to smother the flame. 

12.

 

If the electrical supply cord is damaged, either when being installed or after  installation, it must  be  replaced by 
the  manufacturer, its service agent or similarly qualified persons in  order  to  prevent  a hazard.  

13.

 

The appliance is not intended to be operated  by means of an external  timer or separate remote control system. 

14.

 

Electrical connection must be made as per local wiring rules and regulations.. Do not disconnect the appliance 
with  wet hands  or bare feet, and do not disconnect the power cord with extreme force. If the electrical supply is 
restricted,  means of all-pole disconnection  must be accessible  and  incorporated in the fixed  wiring in 
accordance with the wiring rules. 

15.

 

Ensure that the kitchen is well ventilated or  mechanical ventilation  is in use while cooking on  the appliance. 

16.

 

The  cooktop and oven will become hot during and directly after use. Do not  touch  any components during this 
time,  as they  may be hot  and can cause  burns.  To avoid  burns  young  children should be kept  away. Care should 
be taken  to avoid  touching heating elements inside the oven. 

17.

 

Cleaning may only be commenced  on the appliance once it has cooled  down and is turned  off. Failure to  clean 
properly can damage  the  unit.   Do not  use  a steam  jet  or  any  other  high  pressure cleaning equipment to clean the 
appliance. 

18.

 

Do not use harsh  abrasive  cleaners  or sharp  metal scrapers to clean the glass surface  as they can  scratch the 
surface, which may result in the glass shattering.  Clean the glass using  a w arm  damp  cloth  (e.g. dishcloth). 

19.

 

When the appliance is not being  used, the knobs  must  be kept in the ‘OFF’ position. 

20.

 

The appliance must  be installed and put into  operation by an authorised person under the conditions provided by 
the  manufacturer in this manual. The manufacturer cannot be held responsible for any damage that might occur 
due to faulty  installation. Do not  modify this  appliance. 

21.

 

Use the anti-tilt kit to prevent  the appliance from accidentally falling over. 

Summary of Contents for OF916FKXP























Reviews: