Page : 4
2.- UNPACKING AND INSPECTION
It is advisable to do a detailed reading of this Manual before mounting the instrument. This Operator's Manual
contains all the technical specifications : electricals as well as mechanics, both necessary to do a correct
installation and also a good use of the instrument.
At the same time the user will acquire the knowledge needed to obtain the best performances of the product.
Check that inside the present cardboard box, there are the following :
1 Instrument Model LDP-1X4-MX, J1,J2, K1,K2, T1,T2, E1,E2, S1,S2, R1,R2 & L1.
1 Operator's Manual.
1 Connector for Power Supply.
1 Screw-clamp connectors, 4 pins female for signal inputs.
2 Pieces for fixing the unit against the panel.
REFERENCE KEY
All models have a label on the rear part with their references printed on the following format :
LDP- 1X4-XX-X-X
Number of digits
4 = 4 digits
Display color
R = Red
G = Green
Model reference
Basic serie
Power supply
0 = 230 Vac 50/60 Hz.
1 = 115 Vac 50/60 Hz.
Digit size
2 = 57 mm (2.3")
4 = 100 mm (4")
If there are some doubts or inquiries about the present instrument, please contact OMEGA
ENGINEERING´S customer service department.
When the shipment arrives remove the Packing List and verify that you have received all equipment.
Then inspect the box and the instrument, and if there is evidence of damage caused by bad handling during
the transport, it is advisable to make a careful inspection of all damages making a note of all of them and to
pass on this information directly to the Transport Company.
If this occurs but with insured material, ask the Transport Company for instructions about submitting a claim
