11
WHEn THE SySTEm TRIGGERS
If the system were to be compromised while armed, it will trigger sounding the
siren/horn and flashing the parking lights for 30 seconds (programmable). At this point
you will also be notified on the controller as to which zone is violated (if in range of the
system)� When disarming the system after a trigger event, the siren/horn will chirp 4
times and the parking lights will flash 4 times instead of the standard 2 times.
LOCK On TRIGGER:
If a door is opened when the system is triggered, it will wait
until the door is closed again, then lock the doors� This patented feature is useful to
further deny a thief of further access to the vehicle�
STORm SAFE mODE:
When the system is triggered, pressing the “UNLOCK” icon
will stop the alarm from sounding but will leave the doors locked� This function is use-
ful if you have a false triggering situation due to violent weather�
ZOnE VIOLATIOn RECALL:
The system is capable of telling you which zones were
triggered last� In addition to the controller’s trigger history log (discussed later in this
manual), the system’s status light will flash to indicate which zone was triggered. This
occurs during the alarm cycle AND after disarming� The system will store the last trig-
gered zone until the vehicle’s ignition key is turned on. See “The Status Light” section
of this manual for further explanation of this feature�
nUISAnCE PREVEnTIOn:
If the system prewarns 5 times within 15 minutes, it will
bypass the zone for the remainder of the 15 minutes before rearming the pre-warn
zone. Additionally, if a full trigger zone is left open, the system will trigger a total of 3
times before bypassing the zone. Once the zone is closed again, it will re-arm that
zone.
Security System Features (cont’d)
Using The Valet Switch
EmERGEnCy OVERRIDE
If you were to lose your controller or if the battery were to die while the sytem is
armed, you’d need to perform an emergency override to disarm the system and use
your vehicle� To perform an emergency override, use the following steps:
STEP 1 -
Enter the vehicle (the alarm should sound)
STEP 2 -
Turn the ignition key to the “ON” position
STEP 3 -
Press the valet switch (located in the window-mount antenna) once
NOTE: Enter your SecureCode at this time if programmed via user feature #1
STEP 4 -
Turn the ignition “OFF”�
You can now use the vehicle as normal� It is advised to place the system in valet
mode until you have a functioning controller once again�
VALET mODES
ALARm VALET mODE
, while active, completely disables all security functions�
Keyless entry and remote start are still operable� To enter valet mode, perform the
following steps:
STEP 1 -
Disarm the system either with the controller or by performing an emergency
override (make sure not to hold the brake pedal)�
STEP 2 -
Press and hold the valet switch (located in the window-mount antenna)
for 2 seconds� The system will chirp once and the RED status light will turn on� The
controller will reflect on the status page that the system is in alarm valet mode.
