Page - 10
There are two methods of disarming the system:
Disarming the System
Disarming the System Using
the Transmitter
2-
The second method is an “
Emergency Override
” alternative, should the
transmitter become lost or inoperable. This method uses the Valet
Switch, but the vehicle’s ignition key is also required.
1-
The primary method is to use the
transmitter
by pressing and
releasing its “disarm/unlock” button. This is the normal “daily use” method.
Press and release the transmitter “disarm/unlock” button once to instantly
disarm the system, disengaging the starter interrupt and unlock the doors. If you have
the optional unlock driver's door feature installed, then upon disarming only the
driver's door will unlock, and if the “disarm/unlock” button is pressed again at
anytime thereafter, all of the doors will unlock.
The system’s reaction:
Disarming is confirmed by the siren chirping twice, the
Status Light turning off, and the parking lights flashing twice, then with the interior
lights illuminating for 30 seconds for approach illumination. The lights will turn
off instantly if the ignition switch is turned "on" before the 30 seconds expires.
• Pressing “disarm/unlock” will disarm the system, leaving the doors locked,
stopping both system’s alarm condition (leaving it disarmed) Pressing the
button a second time unlocks the doors.
Prewarning Detection Circuit:
When the sensor is triggered by a light impact
or shock to the vehicle, the security system will respond by chirping the siren 3 times
and locking the doors. After this Prewarning circuit has been triggered five times
it will automatically shutdown until the alarm system is disarmed, then armed.
Feature #12 Parking Light Illumination Upon Disarm
Factory Default Setting
On (
press
“arm/lock” button to program
)
Option:
Off (
press
“disarm/unlock” button to program
)
This feature affects the parking light operation when the
system is disarmed. When
this feature is turned on, the parking lights flash once, and then turn back on for
external illumination for 30 seconds unless the ignition key is turned on during that
time. If this feature is turned off, the parking lights flash once only, and do not
illuminate. This feature only affects the system’s parking light operation, and not
the interior light operation.
Feature #13 2nd Channel Also Disarms System
Factory Default Setting
On (
press
“arm/lock” button to program
)
Option:
Off (
press
“disarm/unlock” button to program
)
“2nd channel” is most commonly used to remotely open the
vehicle’s trunk, in
which case the alarm should also disarm. This feature, turned on, configures the
system to disarm when the 2nd channel is used. If turned off, the 2nd channel output
will still occur, but without chirps or parking light flashes; and if armed, the system
will not disarm.
Feature #14 3 or 45 Second Arming Delay
Factory Default Setting
3 Seconds
(
press
“arm/lock” button to program
)
Options:
15 Seconds
(
press
“disarm/unlock” button to program
)
30 Seconds
(
press “
II
” button to program
)
45 Seconds
(
press
“
III
” button to program
)
When the system is armed, whether by the transmitter or by an automatic feature,
there is a brief period of time in which a system activation, or alarm, cannot occur.
This Arming Delay allows the system to completely process its sensory parameters,
which can include the vehicle to stabilize. In some cases more time is needed than
the factory-set 3 seconds, and this feature offers three longer delay options.
Feature #15 Steady Siren or Pulsed Horn
Factory Default Setting
Steady Siren
(
press
“arm/lock” button to program
)
Options:
Pulsed Horn Low
(
press
“disarm/unlock” button to program
)
Pulsed Horn Medium
(
press “
II
” button to program
)
Pulsed Horn High
(
press
“
III
” button to program
)
It is important to understand that the system has a primary audible output, for the
electronic siren; and that it also has a programmable relay which among its
Page - 31
Multi-vehicle mode:
If the controller is set for CAR1 and CAR2 is triggered, the
controller will temporarily switch to CAR2 and alert you of the violation. It will
switch back to CAR1 5 seconds after pressing any button to acknowledge the
violation.
