Omega CNI8, Manual

Page: 40 / 72

36
ENTER OUTPUT 1 MENU:
Press
a
1) Press
a
, if necessary, until
CNFG
prompt appears.
Press
d
2) Display advances to
INPT
Input Menu.
Press
a
3) Press
a
, if necessary, until Display advances to
OUT1
Output
1 Menu.
Press
d
4) Display advances to
SELF
Self Submenu.
SELF SUBMENU:
The Self Option allows the output of the instrument to be controlled manually
from the front panel.
Press
d
5) Display flashes the current setting of Self,
ENBL
Enabled or
DSBL
Disabled.
Press b 6) Press the b button to select between Enable and Disable.
Press d 7) If Self ENBL Enabled was selected, display shows STRD
stored message momentarily and then advances to the next
menu (Output 1 setting is completed).
The output is now under the direct control of the operator and
can be adjusted in the Run Mode (
M00.0
to
M99.9
), by pressing
the b and c buttons, where M calls for the Manual (Self)
Control. For example, setting of M50.0 of an Analog Output of 0
to 10 Vdc would produce roughly 5 Vdc at the output.
8) If Self DSBL Disabled was selected, display shows STRD
stored message momentarily and then advances to
oPLO
Minimum/Percent Low Submenu of Output 1 Menu.
There is a shorter way to Enable or Disable Self Mode. From a Run
Mode, press
d
and then press
a
. Self Mode is Enabled now. Press
b
or
c to display MXX.X . To disable Self, press d and then press a . Display
goes to the Run Mode. Self Mode is Disabled now.
MINIMUM/PERCENT LOW SUBMENU:
Specify in percent, the minimum value (0000) for control output. If the output is
analog proportional (Current or Voltage), then the minimum voltage or current, in
percent, is specified. If the output is time proportional (Relay, SSR or Pulse),
then the minimum duty-cycle, in percent, is specified.
Press d 9) Display flashes 1st digit of previous “Percent Low” setting.
Press
b
&
c
10) Use
b
and
c
buttons to enter a new value for “Percent Low”.
Press
d
11) Display shows
STRD
stored message momentarily and then
advances to
oPHI
Maximum/Percent High Submenu.