30
85 86
87a
87
3) Momentarily shorting the solder dots together will result in one siren burst. The Personal Coded Override is now returned to the factory-set default
position (1 and 0 presses of the Valet Switch).
4) Shorting the solder dots for several seconds will result in two siren bursts. All of the programmable features are now returned to the factory-set default
positions.
Page 81
EG-1800
ATV
SUPPLEMENT
Personal Coded Override & Total System Reset
Starter Output Adjustment
Satellie Relay Port
Starter Output Adjustment
30
85 86
87a
87
To (+)
12 volt.
Red 3-Pin
Connector
To (+)
12 volt.
To Vehicle's
Additional
Ignition #1 Circuit.
To Vehicle's
Additional
Starter Circuit.
Configuring Optional Relays
For Additional Ignition #1 Or
Starter Circuits.
Green Wire - Additional Negative Starter Output
Blue Wire - Additional Ignition #1 Output
In some cases, a particular vehicle may require more than one Ignition #1 circuit or more than one Starter circuit to be powered up. The EG-1800
ATV
has
a Red 3-pin port providing these two circuits as Negative outputs, which allows easy addition of futher external relays. Certain Omega OEM anti-theft bypasses
also utilize this port. Use this diagram to add additional relays; if needed, two additional Ignition #1 relays can be configured by jumpering the Blue output
wire to both relay's pin #85.
Satellite Relay Port
The EG-1800
ATV
has an adjustable starter output. On top of the control module there is an opening allowing access to this adjustment. Use a small screwdriver
(a slotted jeweler's screwdriver works well) to turn the adjustment. Turning the adjustment clockwise lengthens the duration of the starter output; turning it
counter clockwise shortens the starter output duration. When remote starting, if the signal is acknowledged, the ignition turns on, but the starter fails to engage,
always check this adjustment first; very rarely will it be necessary for it to be at the lowest (counter clockwise) position.
