Page 61
Pink 3rd Channel Output Wire
Plug-In Accessories
EG-1800
ATV
SUPPLEMENT
3rd Channel Output
Pink Wire
The function of the Pink wire is to provide an optional output similar to the Gray trunk release wire. Pressing the proper transmitter button for three seconds
activates this output. Once activated, this output will last for one second, or, for as long as transmitter button is held down, with a maximum of 15 seconds.
This function can be used to activate other optional modules, but for most applications an optional relay will be needed (use the diagram below or the diagram
on Page 51). This output will not disarm the security system when activated. The small lower transmitter button is used to activate this output.
Configuring An Optional Relay
For Trunk Release Or 3rd
Channel Output.
To (+)
12 volt.
To (+) 12 volt or (-)
ground as needed to
operate vehicle circuit.
To Control Unit
Pink Wire
30
85 86
87a
87
To (+)
12 volt.
To (+) 12 volt or (-)
ground as needed to
operate vehicle circuit.
To Control Unit
Gray Wire.
30
85 86
87a
87
To vehicle's trunk
release circuit.
To vehicle's circuit or
optional device.
INFORMATION AND PROGRAMMING MODULE
This module is designed to be mounted on the windshield in view of the driver, and contains the Digital Status Indicator, the Visual Deterrent LED, and
the Valet Switch. The Information and Programming Module also contains the system's receiver section, and mounting high on the windshield enhances the
transmitter's operating range. Carefully clean the glass in the mounting area, then adhere the module to the glass. Plug one 5-way connector into the Information
and Programming Module, route the harness to, and plug the remaining 5-way connector into, the main control module.
SENSOR PORTS
Excalibur Gold ATV security systems feature dual plug-in ports for the electronic sensor devices, which enhances the effectiveness of the system. These
ports are dual-zoned: the first zone will respond by honking the horn (or chirping the optional siren) only; and the second zone will fully trigger, the system.
These ports supply constant 12 volt power, grounded output when the system is armed, a negative instant trigger, and a negative prewarn trigger. Most Omega
Research and Development, Inc. sensors will plug directly into the control module. Sensors are available that monitor shock to the vehicle and radar sensors
that can detect moving objects inside and outside the vehicle. When adding a sensor, follow the installation instructions included with the sensor. After
installing, route the harness and connector from the sensor to the security system control module. Plug the sensor's connector into either one of the module's
Wiring Connections - Plug-In Accessories
