Page 42
Whenever a transmitter is coded into the security system, whether an existing one or previously unknown transmitter, the siren will chirp (or horn will honk)
for two seconds every time the ignition is turned "on", for a period of 48 hours. Additionally, the LED Status Indicator will flash (EG-1400
ATV
) or the Visual
Deterrent LED will flash and the Digital Status Indicator will show (EG-1600
ATV
) the number of transmitters which can operate the system for 90 seconds instead
of 10 seconds. This operation is the Automatic Transmitter Verification
TM
feature, which protects the system from someone programming an unauthorized
transmitter to operate the system.
If desired, all of the features that can be programmed through the Feature Programming Mode can quickly be returned to the factory settings. Changing
individual features were explained in detail in the previous section. However, a Total System Reset feature allows the installer, if needed, to quickly return
all of the programmable features to the factory-set default positions. To perform a Total System Reset, follow these steps:
1) Locate the small round hole in the lower control module case. Two solder dots will be visible beneath this hole.
2) Short the two solder dots together and hold in a shorted condition (a slotted jeweler's screwdriver works well).
3) Shorting the solder dots for a few seconds will result in two siren bursts. All programmable features are now returned to the factory-set default positions.
Total System Reset - EG-1200
ATV
Personal Coded Override & Total System Reset - EG-1400
ATV
& EG-1600
ATV
Total System Reset
EG-1200
ATV
The EG-1400
ATV
and EG-1600
ATV
also have a Total System Reset feature. The installer, if needed, may quickly return all of the programmable features
to the factory-set default positions. However, the initial stage of the Total System Reset returns the Personal Coded Override to the factory default setting
of 1 and 0 presses of the Valet Switch. To perform Personal Coded Override Reset and/or a Total System Reset, follow these steps:
1) Locate the small round hole in the lower control module case. Two solder dots will be visible beneath this hole.
2) Short the two solder dots together and hold in a shorted condition (a slotted jeweler's screwdriver works well).
Personal Coded Override Reset & Total System Reset
EG-1400
ATV
and EG-1600
ATV