During this stage, if you keep turning the feature on and off, the Feature Programming Mode is extended for a further 10 seconds. Remember, 10 seconds
without any programming activity will result in the system automatically exiting the Feature Programming Mode, which is indicated by two long siren
chirps.
Step #6- If needed, repeat steps 4 & 5 to access another feature to turn it on or off.
Step #7- Turning on the ignition, or 10 seconds of no programming activity, will exit the system from Feature Programming Mode, which is confirmed by
two long siren chirps.
1) Passive Arming and Automatic Rearming: If Feature #1 is turned "on", the Last Door Arming and Automatic Rearming Features will operate. Last
Door Arming starts after the ignition switch has been turned "off" and at the last open door is closed. The moment the last door closes the alarm will chirp the
siren, flash the lights, and begin a countdown (during this countdown the LED Status Light flashes fast). Thirty seconds after the last door was closed, the siren
will chirp again, the parking lights flash once, and the LED will begin to flash slow, confirming that the alarm is fully armed. If a point of entry is reopened
before the 30 seconds expires, the countdown stops, and will reset to start again when the door is reclosed.
Upon disarming an armed system, a 90 second Automatic Rearming countdown will start. During this countdown the LED will flash rapidly until any point
of entry is opened, which will temporarily suspend the Automatic Rearming process until reclosed. At the end of the 90 second period the alarm will
automatically arm itself (note that the doors will also lock if Feature #2 is turned "on"). Automatic Rearming is cancelled by turning the ignition switch "on"
before the 90 second countdown ends. To temporarily suspend either Last Door Arming or Automatic Rearming (for example, while refueling) the owner should
put the alarm in Valet Mode or leave the door open. It is not recommend to leave the ignition switch turned "on" for this purpose.
2) Passive Locking and Automatic Relocking: If Feature #2 is turned "on", and the Last Door Arming Feature is utilized, the doors will also lock when
the alarm becomes armed 30 seconds after shutting the last door and also lock the doors when the alarm rearms from Automatic Rearming.
3) Ignition On / Off to Lock / Unlock Doors: If Feature #3 is "on", the doors will lock 2 seconds after the ignition switch is turned "on", and unlock instantly
when the ignition switch is turned "off".
4) Open Door Bypass to Feature #3: If feature #4 is "on" the system will check the vehicle's door circuit. If it detects that any of the vehicle's doors are
open at the time, the doors will not automatically lock when the ignition switch is turned "on", nor automatically unlock when the ignition switch is turned "off".
5) 30 or 60 Second Activation Duration: Feature #5 will select the length of time that the siren sounds and the lights flash when the alarm is activated
or triggered. This can be used when local law requires shorter siren times for noise restrictions. Pressing the small transmitter button when programming this
Feature will select the 30 second timing cycle.
Programming Features - EG-1200
ATV
Page 31
