Page 55
Violet Positive Door Trigger Wire
EG-1800
ATV
SUPPLEMENT
D)
If the Doors Lock With Ignition "On", and Unlock With Ignition "Off" features are turned on along with the Open Door Bypass feature, if a door is open
when the ignition switch is turned "on" with a door opened, the doors will not automatically lock; if a door is open when the ignition switch is turned
"off", the doors will not automatically unlock.
E)
Opening a door during the 90 second Automatic Rearming cycle, or the 30 second Last Door Arming cycle will suspend that automatic function for as
long as the door is open. When the door is closed, the Last Door Arming sequence will restart.
F)
If this wire is grounded at the time the security system becomes armed from the transmitter, the circuit bypass feature will leave the Green wire circuit
unprotected until the circuit becomes ungrounded.
G)
If the system is triggered by the Violet wire, on all models the LED Status Light will flash 3 times and pause until the ignition switch is turned “on”. The
Information and Programming Module's digital display will additionally show "d". The system does not have to reset itself for this feature to operate.
H)
When the ignition switch is "off", if the Green wire becomes grounded, the LED Status Light will flash 3 times and pause for as long as the door is open.
This is the Zone Testing feature, which allows the installer or vehicle owner to visually see trigger circuits which are in a violated state.
I)
If a door is opened and remote starting is attempted, the vehicle will not start and the EG-1800
ATV
will respond with one long and three short siren chirps.
If a door is opened after the vehicle has been remotely started, the system will go into an alarm state and the engine will stop running.
CONNECTION: Connect the Violet wire to a wire in the vehicle which is
common to all the door pin switches. The correct wire for this type of dome
light/door jamb pin switch system will have 12 volts present when the doors
are opened, and chassis ground when the doors are closed. The correct wire
will show this change when any of the doors are opened. If the car has a
delay dome light the Circuit Bypass feature will allow the
system to be armed from the transmitter instantly
and will start protecting the Violet wire circuit
when the dome light turns off. In Last Door
Arming mode, the system arms 30 seconds
after the dome light turns off. The following
diagram illustrates a basic positive
courtesy light system:
1
1
12
12
12
12
12
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
Passenger
Pin
Switch
Driver
Pin
Switch
This Is
The Correct
Trigger Wire.
To
Chassis
Ground
To Constant
(+) 12 Volt
Typical Positive Dome Light System.
Dome
Light
Please see the note on the
following Page concerning this wire.
